How Cleaning Out Dryer Lint Made Me Money

Updated on November 30, 2017
Anne Ryefield profile image

Anne strives to be self-sufficient. She takes pride in knowing she can fix things on her own and wants to teach others to do the same.

According to the National Fire Protection Association, there were 15,970 fires involving clothes washers and dryers between 2010 and 2014. In these four years, ninety-two percent of the fires were caused by clothes dryers specifically. Of those fires, twenty-seven percent were caused by dust, lint, or fiber. A further twenty-six percent were caused by clothing. As far as washer fires go, fifty percent were caused by wire or cable insulation and appliance housing or casings.

With almost 4,000 fires caused by dryers and washers a year, it seems they are unsafe to have within the home. This, however, isn't actually correct. According to the U.S. Fire Administration, thirty-four percent of dryer fires are caused by failure to properly clean the appliance. One of the most basic maintenance tasks involving dryers is cleaning the lint trap before and after each load of laundry. Unfortunately, I could not find statistics on how many people forgo even this most basic task. It is hoped that anyone who uses a dryer knows to clean the trap at least once in a while.

Based on statistics, it is decidedly true that most people do know they should be doing more to care for their dryers and limit the risk of fires. Even though I've always had a dryer in my home, from childhood on to today, I only recently learned about how much maintenance a dryer really needs. I feel lucky knowing that I should be doing more than just cleaning the lint trap. Why? Because dryer lint made me money.

Anne's very small laundry room. Anne had to stand outside to take the picture!
Anne's very small laundry room. Anne had to stand outside to take the picture!

The Victims of My Experiment

Above you see my laundry room. This was taken after I cleaned my dryer but before I got around to getting the lint off of the walls (which I still need to do). I own a Kenmore 80 series dryer and a GE washer. Both have worked very well. The washer was a brand new scratch and dent I got from work. I got the dryer from someone else in the mobile home park where I currently live. I did not see the dryer before it was purchased, nor did I install it. In all honesty, I wasn't even the one who purchased it. I was told it was "like new" and "only a few years old", but both statements have proven to be untruths.

I got the dryer in early 2016. I got the washer in September 2016. Both have done their jobs with little trouble. As anyone else would think, that's pretty much the end of it. You plug them in, attach the hoses and vents, throw in some laundry and go. Up until right before Thanksgiving of this year (2017), this has worked for me. That is, until I began noticing a slight burning smell and lint covering everything in the laundry room. I do mean everything - walls, floor, shelves, ceiling. Based on what little I knew, I felt this wasn't right. So, I hit the internet and decided that maybe the dryer duct that connects to the dryer may have come loose.

That is where my adventure began.

After Cleaning Lint Drifts.
After Cleaning Lint Drifts.

The Problem

I had decided one night to clean the floating lint in the laundry room while I waited for my last load of laundry to finish washing. This turned out to be both a terrible and a fantastic idea. After gently pulling the dryer from the wall, I found lint in snow drift style piles in the corner and along the walls. I also discovered the cheap duct had both disconnected from the dryer and split almost completely in half at floor level. The person who installed the dryer used cheap shipping tape to attach the vent to the dryer. Dryer clamps are the preferred and safest method. It was at this point that I knew I'd have to replace the vent before doing the rest of my laundry. Unfortunately it was a project for the next day as I didn't want to crawl around under the mobile at midnight.

I also discovered another problem. In my research concerning my lint problem, I read that a common problem was an accumulation of lint in the ducting. This accumulation would be just like a person's arteries, slowly blocking the flow until the heart attack, or fire, happens. I figured I should take a reach into the ducting while I was cleaning up to see how badly my dryer's arteries were clogged.

I was horrified.

Fire starting lint pulled from the dryer duct.
Fire starting lint pulled from the dryer duct.

A Near Disaster

I couldn't pull the dryer duct all the way out of the floor. It was connected somehow underneath the mobile. I reached in and didn't get much higher than my wrist before I was pulling out lint. I was used to lint being soft fuzzy stuff that, while kind of gross, could almost pass for one of those sweaters I used to wear in the 1990s. This wasn't the same kind of lint. It was hard and solid. It was compact and heavy. It was wrong.

I kept pulling lint out until I couldn't reach anymore. The picture above is only a part of what I pulled out. That night, I ended up with almost eight pounds of this fire starter. I hadn't even gotten it all. I knew I hadn't. I didn't know how long the vent was but I did know there would be more. I felt like I had somehow just missed the very real danger of my house burning down. The lint was warm. I'd been running the dryer most of the afternoon and evening. The lint was far warmer than it should have been. It wasn't smoking but some of it gave off that odd burning smell I'd been experiencing for several weeks.

I knew I couldn't use my dryer again until I replaced the duct and cleared out all of the lint. In my research, I discovered that I'd have to do more than slap on a new duct. It seems that lint can and does collect inside of the actual dryer. This is just as much of a hazard as the monstrosity I pulled from the clogged duct. In order to preserve my level of perceived safety, I would have to open up my dryer and clean out the lint I was sure was there. I could feel it in the Force waiting to get me.

The beginning of proper cleaning of a dryer.
The beginning of proper cleaning of a dryer.

Out of the Fire

After being paranoid all night wondering if the warm lint I couldn't pull out of the clogged duct would start a fire, I got up early to begin the recommended cleaning I'd read up on. As my laundry room is far too small to actually work in, I muscled my dryer out onto the even smaller back deck. The steps allowed me to sit semi-comfortably while cleaning.

The outside of the dryer was covered in a very fine layer of lint. I could see that the hole where the duct connects was dirty. I knew that I would have to remove the back cover in order to access the important parts of the dryer.

The black plate was held on by bolts. I needed to use a socket wrench and two different bits to remove the small black plate above the cord and then the large black plate. A socket wrench made the job easy and quick. It also granted me access to a lovely surprise.

A surprise in the lint.
A surprise in the lint.

All Worth It

The picture above is the view I had as I began to lift the black plate away from the dryer. It was windy that day so as soon as I saw what was inside the dryer, I stopped. At the bottom of the dryer, under the heating element, I found something that was worth the bruises I got wrestling this bulky machine out of a just-barely-big-enough door. Covered in lint and dust, I saw paper money.

I quickly secured the black plate and ran into the house for a plastic bag. I again removed the plate and started to shovel all the debris into the bag. Lint, hair ties, screws, pen caps, and two button pins I'd been missing all came out. So did coin money and stiff crumpled bills. I saw dollar signs as I removed more and more. It was very difficult not to stop there and count my treasure. Instead, I secured the bag, tossed in back into the house, and continued to clean.

Before removing the lint trap vent.
Before removing the lint trap vent.

Deep Cleaning

It took a good twenty minutes to get all of the loose debris out. Every few minutes I was pulling out a coin or two. A few more bills appeared as I dug under the drum. Soon, it just looked like I needed to run a wet cloth over the surfaces. I still needed to take the lint trap vent off. I knew that it had to be clogged if all of the back was covered in lint.

The lint trap vent.
The lint trap vent.

Where the Problem Begins

The lint trap is that funny little screen that is either right inside of the door or on top of the dryer. You're supposed to clean it out before and after each load of laundry. I've always done this, though I don't often clean the trap after my last load. I do check it every time before turning on my first load. In dryers where the lint trap is on top, the vent is pretty easy to remove. I just undid three or four bolts and carefully pulled down and out. I found my dog's lost cousin in the vent. Most of the debris is dog hair and heavier particles. Yuck!

More things to clean
More things to clean

The End Is Neigh

After dumping the gross accumulation into the trash, I sent the lint trap vent to the tub where I washed the remaining debris out. I went back out to the dryer and took the vacuum to all I could reach. The screen and its seal, the motor fan, the hole for the dryer duct, the wires, the little plastic cradle where I'm positive large objects like money falls through, and the outside of the heating element all got a good vacuum and rub down with a wet rag. This took the longest, oddly, because I was still taking up so much lint with the rag. Some of the lint had burned onto the metal and needed a scrapping to come off.

Lint from the ducting under the house.
Lint from the ducting under the house.

Under the House

After the scrub down, I knew I had to let it all dry properly. It was time to go under the mobile and fight the duct. I don't have pictures of that adventure. I felt the spiders would steal my phone when I wasn't looking. It took very little time to loosen the broken duct from its attachments. It was stiff with hardened lint. A solid chunk came crashing down on me as I removed the duct from the floor. It earned a photo opportunity.

I replaced the duct with a new one of similar design. They aren't the most safe types of ducts, with the USFA recommending smooth sided metal ducts. Another good alternative is a semi-rigid aluminum duct. If I owned my home, I would have gone with the recommended ducting. However, as I rent, I felt it was not appropriate to modify the house to that extent. I went with the cheaper option.

In all, I ended up with almost fifteen pounds of compacted lint from that broken dryer duct. Most of it probably wasn't from my use. I have a feeling that the duct had been in place for many years. I know the person who installed my dryer did not replace the duct as he should have. My home was in danger before I even moved in.

Spoils of war
Spoils of war

Safe for Another Day

After replacing the duct and putting my skirting back on, it was time to put the dryer back together. The process was as simple as it was taking it apart. I only had to do exactly as I did before, but in reverse order. The lint trap vent was put back on, though it was a just slightly more difficult to get it in than it was getting it out. Wires were put back in their proper places (I took a picture before disassembling just to be sure). The black plate was wiped down and then secured back on. Finally, the little black plate above the cord was replaced, making sure the ground wire was secured as well.

Several hours of cleaning led me back to manhandling the beast into the house again. A clinched jaw and the knowledge that I had done it once before let me lift and push it back into it's proper place. I attached the new duct to the back, with a proper clamp this time, and gently scooted it back into place. It's important to make sure the dryer is not pushed too close to the wall and that the vent isn't crushed. I plugged it back in, leveled the legs, prayed and turned it on.

There was an immediate burning smell. I panicked. Before I could do anything, the smell began to dissipate. A sigh of relief. It must have just been bits of lint I couldn't reach. The dryer was okay. Not only was it okay, but it was quieter. It didn't have dozens of metal objects vibrating around. It was leveled better.

Evening had arrived by the time I stood at the counter sorting lint from the treasures I found in the dryer. The plastic bag was emptied of its contents and I organized my finds. In all, I recovered stuff that wasn't mine (the hair ties, buttons, pen caps, screws) and found $47.29. There was a $20 bill and two $5 bills in that dryer! I was amazed. They were stiff from their rides in the washer and slightly burned from the heat of the dryer.

While it's not a lot of money, it's $47.29 I didn't know I had. I do not know of anyone who is opposed to free money.

Dryer Money
Dryer Money

Peace of Mind

Finding money wasn't the only way lint put money in my pocket. Now that my dryer can properly breathe, it takes less time running to dry the same amount of clothes. I've found in the past week and a half that my load of towels went from sixty minutes to dry to forty. My sheets are done in twenty and that's including the cool down period. The dryer running less for each load means I'm using less electricity. While I can't confirm how much less at this time, I know that the few dollars it saves every month adds up. Even if I am now saving a dollar each month because I'm running my dryer for less time, that's still twelve dollars a year. That's an extra month of Netflix. I also don't have to worry about the clogged artery of a duct heating up and catching fire. I don't have to worry about getting my elderly grandmother out of the house because the mobile home has gone up in flames while doing laundry. I don't have to worry about losing everything I own either. I can now rest easy knowing that I've cut my fire risk down significantly.

Myriams Photos via pixabay.com
Myriams Photos via pixabay.com | Source

Recommended Dryer Maintenance

The USFA has several guidelines for keeping your dryer safe. In addition to following the manufacturer instructions in your dryer's user manual, you should also preform the following steps:

  • Clean the lint trap before and after each load of laundry.
  • Clean lint from the back of the dryer as needed or every six months.
  • Use a lint trap brush as needed or every six months. ()
  • Clean the dryer duct every three months or more if clogged.
  • Have your dryer cleaned by a professional regularly (or my recommendation, save your money and learn to do it yourself).
  • Regularly inspect the venting system (ducts) to ensure they are intact and not crushed or blocked.

In addition, it is always wise to:

  • Check that the vents outside are covered to prevent rain and snow from entering.
  • Check to make sure the vents open when the dryer is on.
  • Check to make sure the screen in the vent is free of holes to prevent insects and mice from entering your dryer duct.

The USFA website has many tips on how to properly care for your dryer. It is always best to follow these guidelines to ensure the safety of your home and extend the life of your dryer.

How Often Do You Deep Clean Your Dryer?

See results

© 2017 Anne Ryefield

Comments

    0 of 8192 characters used
    Post Comment

    • KT Dunn profile image

      KT Dunn 2 weeks ago from United States

      This is really interesting and useful information, and I enjoyed reading about your dryer adventures!

    Show All Categories