Unless it's a large pipe, say perhaps 3 or 4 inches, a 3 bend saddle will do fine. If it's a large obstruction in the way a 4 bend saddle will likely do better.
How do you bend small offsets like 1 inch or 1 1/2?
I will try and keep this as simple as possible. I’m running 2 - 2.5 “ and 2 - 2” EMT coming out of a 12x12 box above the ceiling 60” with a 6 “ kicked 90. When I proceeded to bend the 2” conduit with same exact measurements the KICK angle was nowhere near matching the 2.5s. How can I match the angle of 2.5s?
A 1" EMT bender can be used to bend 3/4" Rigid. Do all of the deducts and multipliers that apply to the 1" EMT apply to the 3/4" Rigid?
Copyright © 2018 HubPages Inc. and respective owners. Other product and company names shown may be trademarks of their respective owners. HubPages® is a registered Service Mark of HubPages, Inc. HubPages and Hubbers (authors) may earn revenue on this page based on affiliate relationships and advertisements with partners including Amazon, Google, and others.
Copyright © 2018 HubPages Inc. and respective owners.