You will have to go to a distributor in your area and likely purchase a Honeywell. You need the measurement of the rod coming off the back.
If the limit switch is bad and I have another switch from another furnace that looks the same, can I use it?
The part says L350 36tx16 manual limit switch. What does manual mean? Did I order the wrong part?
I'm installing a new draft inducer (exhaust blower) that came with four limit switches that have four different colored dots (white, yellow, red & blue) on them. I have only two limit switches on my furnace, the upper limit switch is blue dotted and the lower is yellow dotted. Am I correct to use the new yellow dotted limit switch since I am only replacing my current yellow dotted lower limit switch?
I'm getting 4 flashing lights from my furnace, meaning an open limit switch. It is -40c today so I'm wondering is it overheating and turning off just because it's having a hard time keeping up? Or is there an actual issue?
Furnace kicks on. Home temp reaches desired temp. Then the burners turn off but the blower keeps blowing. Normally the blower turns off after approx 100 seconds but occasionally will continue to blow and the only way to turn off is the fuse box. Can it be the switch above the burners or the switch that is by the blower?
What would be the main cause of having to replace the ignitor on my furnace three times in the last four months?
Copyright © 2018 HubPages Inc. and respective owners. Other product and company names shown may be trademarks of their respective owners. HubPages® is a registered Service Mark of HubPages, Inc. HubPages and Hubbers (authors) may earn revenue on this page based on affiliate relationships and advertisements with partners including Amazon, Google, and others.
Copyright © 2018 HubPages Inc. and respective owners.