This is programmable? It means it's getting back to an "occupied" set point. I.e., You were gone, so program for one temp and then another for your return...it's in "recovery".
The thermostat panel went blank while the furnace was on. Now, it is blowing cold air. How do I turn it off, and what can it be?
The vent pipe from my furnace to the chimney is to hot to touch. Isn't this a lot of waste?
Why would I have voltage running through my gas lines on the furnace?
Why is the zone 2 light red on my Honeywell furnace? Is it not working?
Why does the flame stay on when a furnace is off?
The red light on my furnace stays solid? Any suggestions?
Copyright © 2018 HubPages Inc. and respective owners. Other product and company names shown may be trademarks of their respective owners. HubPages® is a registered Service Mark of HubPages, Inc. HubPages and Hubbers (authors) may earn revenue on this page based on affiliate relationships and advertisements with partners including Amazon, Google, and others.
Copyright © 2018 HubPages Inc. and respective owners.